Enum PipeCorners 

pub enum PipeCorners {
    Mitre,
    Extended,
    Round,
}

How a pipe turns a sharp corner of its spine.

Variants

Mitre

The walls sheared onto the plane halving the corner.

Extended

Each leg runs on straight past the corner until its section clears the other leg’s far side, and the legs are fused: the outside of the corner square.

Round

Each leg ends square at the corner and the section turns about the corner through its angle, joining the two ends: the outside of the corner rounded.

A face’s corner is the union of the legs and its section’s half outside the turn revolved about the corner’s axis, and a closed wire’s is that solid’s walls. An open wire bounds no solid: its sheet is rounded point by point, each point of the section outside the turn turning about the axis and each point inside cut on the plane halving the corner. A closed wire split into open ones sweeps its walls so only where each point of it inside the turn reaches the corner’s axis across the section’s interior; a section turned about the spine so that its walls inside the turn are covered by the other leg (a tilted square) does not.

Trait Implementations

impl Clone for PipeCorners

fn clone(&self) -> Self

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Copy for PipeCorners

impl Debug for PipeCorners

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for PipeCorners

fn default() -> Self

Returns the “default value” for a type.

impl Eq for PipeCorners

impl PartialEq for PipeCorners

fn eq(&self, other: &Self) -> bool

Equality operator ==.

fn ne(&self, other: &Rhs) -> bool

Inequality operator !=.

impl StructuralPartialEq for PipeCorners